Read Any Good Plano Water Meters Lately?
Knowing how to read your water meter allows you to easily and quickly track water usage in your Plano home, including trends and potential spikes due to leaks. If you discover high usage, it would be advisable to contact your Plano plumber who will be able to find the exact location and repair the leak before your water bill continues to increase needlessly. Most water meters are one of two types: a straight-reading meter or a dial-reading meter. A straight-reading meter contains a simple number tally that provides the readout, while a dial-reading meter contains either five or six distinct dials that are used to determine the overall usage.
Things You’ll Need
Reading a dial meter
- Use a screwdriver to remove the lid of the water pit. Check the area for any dangerous insects or animals before proceeding.
- The dials are labeled in increasing tenth values (i.e. 10, 100, 1000, etc). Begin reading the water meter with the highest value dial, generally the 100,000 dial. Note the smaller of the two numbers nearest to the needle as the first digit.
- Read the dial labeled 10,000 and note the smallest of the two numbers nearest to the needle. Continue this procedure until you have read all dials and have a full six-digit number. The final number provides the units of water in either gallons or cubic feet that have been consumed since the meter was installed.
- To monitor water usage, simply subtract the “before” reading from the “after” reading and the result will be the amount consumed over a specified period of time. This value can assist with monitoring usage
- If the value given by the readout is in cubic feet, you may want to convert the value to gallons. One cubic foot is equal to 7.48 gallons. As a general rule, water companies will charge you based upon usage in terms of either 100 cubic feet or 1000 gallon units. The best way to know how you are charged is to check your Plano water bill, which should indicate the unit of measure.
Reading a straight meter
1. Locate the number tally on the water meter and record the number listed. It is the area that looks similar to a car’s odometer.
2. Determine the unit of measure. It is generally listed as either cubic feet or gallons in the area above or below the number tally.
3. Subtract the “before” reading from the “after” reading to determine usage.
4. Convert the value of the readout as needed (between gallons and cubic feet) for consistency with how your Plano water company bills you for usage.
Tips & Warnings
- To determine whether or not a leak is present, turn off all of the water outlets in your Plano home and note the position of the 1-cubic-foot-dial on your water meter. After 30 minutes, check the dial for movement. If the dial has moved, then you have a possible water leak in your home. Call your Plano plumber for assistance in finding and repairing the leak before your water bill skyrockets.
- Many new water meters have digital readouts which provide a straight number for consumption and do not require any special techniques for reading.
- H2ouse: How to Read Your Water Meter
- “Complete Home Plumbing;” Scott Atkinson; Sunset Books; 2001